 
The time clock is set to carry out its regeneration on set days. This is usually calculated by the hardness of your water supply, the capacity of the water softener and usage.
When installed, the softener is set to regenerate at usually 2.00a.m. at the calculated regeneration frequency.
To ensure that soft water is always available, the interval between regenerations will be under estimated rather than over estimated.
The softener will then regenerate at this set interval regardless of the volume of water used.
Choose from CW20, CW30, CW50 Water Softeners depending on the required flow rate and soft water capacity.
CW20 Timed Water Softener Specification:
Resin Volume
|
20
|
| Vessel |
8x35" |
| Flow |
0.8 |
Capacity @ 300ppm
|
3.3 |
Valve Type
|
255/WS1 |
Salt (kg)
|
3 |
Brine Tank Volume
|
35 L
|
Brine Tank Width (B2)
|
320 mm
|
Brine Tank Height (H2)
|
440 mm
|
Vessel Width (B1)
|
220 mm
|
Vessel Height (H1)
|
904mm |
Simplex Water Softener
Term used for a single vessel system, we supply industrial softeners that regenerate on either a time controlled basis or meter controlled for where the usage will tend to vary from day to day. Typical application are where the usage per day has been calculated and will not vary hugely, whilst not being required 24 hours per day.
We will be pleased to provide a comparative quote against your existing supplier
or supply technical information on any of our products.
Call us for the best prices and advice. Tel: 0845 10 80 680 / 01403 701970
|
